![msh brain flybarless system software download msh brain flybarless system software download](http://raysupernal.weebly.com/uploads/1/2/4/0/124053361/865651596.png)
Now the FrSky Integration doesn’t hang when particular values are read or written.Now FrSky Integration during the use, no longer generates the tedious messages of 'Telemetry lost'.Now external sensors connected on the FrSky Smart.Port bus no more freeze the FrSky Integration.
Msh brain flybarless system software download code#
Simplified, optimized and speeded the code and greatly reduced the total size of the precompiled FrSky LUAC script to leave the RAM space for other little LUA script running in background.New version of FRSKY script file for integration ac inside the downloadable Brain2FrSky.zip file.Renamed the JETI integration file under “Help” menu and on the server from “Brain.zip” to “Brain2Jeti.zip”.Updated version of JETI integration file brain.bin inside the downloadable “Brain2Jeti.zip” file with all the recent firmware and software changes.Introduced a further improvement in current measurement with Hobbywing ESC’s.Wizard panel 9 & ADVANCED, Tab Common, Receiver: now when the Tail Gain checkbox 'Is set in Software' was selected (or unselected), the radio channels for “Tail Gain” and 'Setup Selection' are automatically exchanged between them.Checkbox “Spektrum Bind” to put by software RX/SAT in to bind mode, now work also when Spektrum SRXv2 protocol is selected.From this version it is officially added the decoding of new Spektrum SRXLv2 protocol used by Spektrum for their new receivers (for now only SPM4650) selecting the “HoTT/SUMD/UDI/Xbus-B/SRXLv2/Mpx-SRXL(oldest Spektrum rx)” icon / protocol with possible physical redundancy using 1/2 DSMX satellites.Added in parameters that can be managed with Jeti telemetry Z-Acceleration, X-Acceleration and Y-Acceleration.Now it is possible to log also values of Z-Acceleration, X-Acceleration and Y-Acceleration (in G units).Added message “SWASHPLATE NOT SELECTED” in panel 8 of the Wizard if swashplate was not correctly done.Added further controls for the swashplate displayed as selected in panel 7 of the Wizard.Wizard: moved panel 9 “Unit Orientation” to panel 2, all other panels are scaled by one position.If required, correct swashplate movements with “Servo Reverse” button. If swashplate movement are not correct go into the panel 8 and:Ĭheck that SRV-1 of the top left displayed swashplate is connected to SRV1 input of the unit, SRV-2 in to the SRV2 input and SRV-3 in to the SRV3 input. IF ANY SWASHPLATE IS SELECTED: Select the correct kind of swashplate used on your model (a unit power cycle can be required), then check that swashplate movements are correct. IMPORTANT NOTE: Immediately after the update, go to panel 7 of the Wizard and check that your swashplate is selected (or if in panel 8 of the wizard appear the message “SWASHPLATE NOT SELECTED”).